Need help?Do you have a question about the Husqvarna 165R and is the answer not in the manual?
Details on ignition system type and advance timing.
Recommended spark plug models and correct gap setting.
Specifies the carburettor model and its basic adjustment settings.
States fuel tank capacity and recommended fuel-oil mixture ratios.
Lists harness type, saw blade, shaft angle, and weight.
Details recommended grease and cylinder/piston classification.
Outlines pressure and leakage limits for testing.
Describes a functional check for the starter's return spring.
Specifies pressure requirements and leak checks for the carburettor.
Explains lubrication via fuel-oil mixtures for two-stroke engines.
Testers and tools for ignition and electrical system checks.
Wrenches, drivers, and pullers for mechanical tasks.
Devices for measuring engine speed and system pressures.
Greases, sealing plates, and sleeves for assembly.
Kits and tools for repairing electrical wiring and connections.
Tools for removing specific components like sealing rings and gears.
Jigs and fixtures to facilitate assembly processes.
Various glues, adhesives, and threadlocking compounds.
Specific tester for SEM ignition systems.
A specific screw used with puller tools.
Step-by-step guide for disassembling the carburettor.
Instructions for inspecting the carburettor's metering system components.
Procedures for checking the pump, passages, and filter.
Guidance on cleaning passages and checking throttle shafts.
Steps for reassembling the carburettor after maintenance.
Instructions for mounting the carburettor onto the engine cylinder.
Comprehensive guide for adjusting carburettor settings for optimal performance.
Detailed steps for fine-tuning the low-speed carburettor needle.
Detailed steps for fine-tuning the high-speed carburettor needle.
Troubleshooting steps for identifying electrical system issues.
Procedures for removing starter and ignition coil components.
Steps for reassembling electrical system parts.
Guide for removing the cylinder casing and piston.
Checks for damage, wear, and condition of cylinder walls and piston rings.
Instructions for fitting the piston to the connecting rod and cylinder.
Steps for separating crankcase halves and removing components.
Procedures for checking crankshaft integrity and connecting rod play.
Guide for fitting crankshaft, bearings, and assembling crankcase halves.
Steps for taking apart the starter mechanism.
Instructions for reassembling the starter components.
Verification of correct starter function after assembly.
How to adjust handlebar position for optimal ergonomics.
Steps to set the throttle control lever's desired position.
Instructions for adjusting the spring tension of the throttle control.
Procedures for dismantling and assembling the engine unit to the drive shaft.
Steps for dismantling the clutch housing and suspension tube.
Guide for replacing front and rear vibration damping components.
Procedures for dismantling and assembling the drive shaft tube.
Inspection and replacement of the centrifugal clutch and drive shaft.
Dismantling, removal, and assembly procedures for the angle gear.
Steps for removing and mounting lower and upper bearing housings.
Procedures for replacing gear shafts and mounting the blade guard.
Instructions for lubricating the angle gear with specific grease types.
To Next Page
General