9
Starter H
Removal
Remove the screws that retain the starter. Set the return spring to zero by
pulling out the starting cord by abt 30 cm, put it into the groove of the
pul Iey rim and let the wheel turn slowly backwards (slow it down with your
thumb).
Loosen the screw and remove the washer in the centre of the pulley.
Lift off the pulley.
Remove the screws that retain the plastic cover over the return spring.
Remove the cover and the spring.
Assembly
Put the return spring, a new one if necessary, into the starter housing. Lubri-
cate with a few drops of ordinary engine oil.
Put the plastic cover back and tighten the screws.
If necessary, exchange the starting cord and fit it on the pulley. Wind up the
cord 3 turns on the pulley (Note! right direction) and put it in its place in the
starter housing. Check that the spring grips the pulley, then fit the washer and
the screw.
Pull the cord through the cord sleeve of the starter housing and through the
starting handle. Make a knot in the cord and pull the knot completely into the
handle. Put the cord into the groove of the pulley rim and tighten the spring
enough to get 1/4 spare round. Fit the starter and check that no electrical
cables are squeezed.
To Next Page
Loading...
