Safety Equipment [ I ■
4
m
B. Changingthe throttle safety
catchand the throttle lever
Dismantle the tank unit as described in chapter 8, under the heading “Removal
of crankcase”.
Remove the two upper rear vibration dampers with U-spanner No.
5025066-02. Remove the throttle lever shaft and the lever.
The safety catch is removed by pushing out the roll pin with a drift @ 2 mm.
Reassembly is made in reverse order to dismantling.
Check that the spring enters the groove of the safety catch correctly and that
the throttle lever works properly.
C. Changingthe chain catcher
Do not forget to check the chain catcher and change it when damaged.
Remove the clutch cover. Use Allen key No. 5025018-01 to remove
the screw retaining the chain catcher.
39
To Next Page
Loading...
