Need help?Do you have a question about the Husqvarna 242XP and is the answer not in the manual?
General| Power output | 2.2 kW |
|---|---|
| Vibration level (front/rear handle) | 3.5/4.5 m/s² |
| Weight | 4.6 kg |
| Fuel tank volume | 0.5 l |
| Oil tank volume | 0.25 l |
| Chain pitch | 0.325 inches |
Lists required service tools for specific procedures.
Information on safety precautions for repair and service.
Describes the intended audience for the manual.
Explains how the workshop manual can be used.
General safety guidelines for workshops and personnel.
Specific safety warnings and precautions for chain saw operation.
Lists general tools applicable to all Husqvarna chain saws.
Lists tools specific to various Husqvarna chain saw model groups.
Service data and component diagrams for Husqvarna saws 36 and 41.
Service data and component diagrams for Husqvarna saws 40 and 45.
Service data and component diagrams for Husqvarna saws 51 and 55.
Service data and component diagrams for Husqvarna saws 61, 268, and 272.
Overview of common chain saw faults and their probable causes.
Describes procedures for testing components and sub-systems.
Covers dismantling, cleaning, inspection, assembly, and testing of the chain brake.
Details on chain catcher description and replacement procedures.
Instructions for muffler dismantling, cleaning, inspection, and assembly.
Covers dismantling, cleaning, inspection, and assembly of the stop switch.
Procedure for dismantling the starter unit.
Instructions for removing and fitting a new ferrule in the starter.
Steps for assembling the starter unit, including cord and spring.
Covers checking, dismantling, and assembly of the ignition system.
Description, troubleshooting, and checking of the electric handle heating system.
Procedure for dismantling the centrifugal clutch.
Steps for cleaning and inspecting clutch components.
Instructions for reassembling the centrifugal clutch.
Procedures for dismantling the oil pump for various saw models.
Steps for cleaning and inspecting oil pump components.
Instructions for assembling the oil pump for various saw models.
Explains the principles of carburettor design and operation.
Procedures for dismantling carburettors, including plugs and jets.
Steps for cleaning and inspecting all carburettor components.
Instructions for reassembling carburettor components and performing pressure tests.
Instructions for cleaning and oiling the prefilter.
Guidance on cleaning or replacing the main paper filter.
Procedure for removing the tank unit from the engine sub-assembly.
Checks for fuel pipe, tank, breather, cap, and filter integrity.
Instructions for fitting a new fuel pipe and reassembling the tank unit.
Procedure for removing rubber elements or coil springs.
Instructions for fitting side absorbers and damper elements.
Procedure for removing the piston and cylinder from the engine.
Steps for cleaning and inspecting piston, cylinder, and ring.
Instructions for assembling the piston and cylinder.
Procedure for splitting and dismantling the crankcase halves.
Checks for bearing play, wear, and cracks in crankcase components.
Instructions for fitting bearings, seals, and assembling crankcase halves.
To Next Page
