What to do if my Husqvarna 339XP Chainsaw is difficult to start?
If your Husqvarna chainsaw is difficult to start, here are some potential solutions: * Adjust the L-screw. * Check if the air filter is blocked. * Examine the choke to ensure it is functioning correctly. * Inspect the choke axle and valve for wear. * Ensure the fuel filter and fuel line are not blocked. * Check for a seized piston ring or a blocked impulse channel.
Why is my Husqvarna Chainsaw Carburettor leaking fuel?
If your Husqvarna chainsaw carburettor leaks fuel, it may be due to: * A loose or faulty fuel pipe. * A hole in the diaphragm. * A worn needle or needle tip. * A sticking control system. * A control system set too high. * A leaking control system (air or fuel). * A loose cover on the carburettor’s pump side.
What to do if my Husqvarna Chainsaw does not idle?
If your Husqvarna chainsaw does not idle, consider the following: * Adjust the L-screw. * Check for a leaking inlet manifold (rubber) or loose carburettor mounting. * Inspect the fuel pipe for leaks or faults and ensure the fuel filter and fuel line are not blocked. * Make sure the tank ventilator is not blocked. * Examine the throttle valve axle for stiffness and ensure the throttle isn't sticking. * Check the throttle return spring for defects and the valve axle stop for bending. * Inspect for a faulty diffuser jet.
Why does my Husqvarna Chainsaw flood when the engine is not running?
If your Husqvarna chainsaw floods when the engine is not running, it could be due to a worn needle or needle tip, a control system set too high, or a sticking control system.
What causes too much fuel while idling in my Husqvarna 339XP Chainsaw?
If your Husqvarna chainsaw has too much fuel while idling, it could be due to the control system being set too high or sticking. Other potential causes include a damaged or incorrectly fitted control system, a worn needle or needle tip, or a leaking diaphragm/cover plate.
Why does the L-screw on my Husqvarna 339XP need constant adjustment?
If the L-screw on your Husqvarna chainsaw needs constant adjustment, it may be due to a blocked fuel line, a control system set too high or sticking, a leaking control system (air or fuel), a leaking diaphragm/cover plate, a faulty diffuser jet, or a leaking crankcase.
Why is my Husqvarna Chainsaw idling unevenly?
If your Husqvarna chainsaw idles unevenly, consider the following: * Check for a blocked fuel filter or fuel line. * Inspect for a leaking inlet manifold (rubber) or loose carburettor mounting. * Examine the throttle valve axle for wear and ensure the throttle valve screw is not loose. * Check for a worn throttle valve, a sticking control system, or a leaking control system (air or fuel). * Inspect the control system’s centre knob for wear and check for a hole in the diaphragm. * Look for a leaking diaphragm/cover plate or a leaking crankcase.
Why my Husqvarna Chainsaw is idling with closed L screw?
If your Husqvarna chainsaw is idling with the L screw closed, it might be due to a worn needle or needle tip, a leaking diaphragm/cover plate, a sticking control system, a worn lever arm in the control system, or a faulty diffuser jet.
How to fix too rich idling on my Husqvarna 339XP?
If your Husqvarna chainsaw has too rich idling, try to adjust the L screw. Other potential causes include a worn needle or needle tip, a control system set too high, a worn lever arm in the control system, a leaking diaphragm/cover plate, or a control system sticking.
To Next Page
General
