3. Remove the screw and the chain catcher.
4. Examine the chain catcher for wear and damages.
Replace the chain catcher if it is worn or damaged.
5. Install in the opposite sequence.
5.3 Chain tensioner
5.3.1 Drive sprocket cover attached with a bar knob
5.3.1.1 To adjust the tension of the saw chain
WARNING: A saw chain with an incorrect
tension can come loose from the guide bar and
cause serious injury or death.
A saw chain becomes longer when you use it. Adjust the
saw chain regularly.
1. Loosen the bar knob that holds the drive sprocket
cover.
2. Lift the front of the guide bar and turn the chain
tensioning wheel. Tighten the saw chain until it is
tight against the guide bar.
3. Tighten the bar knob and lift the front of the guide
bar at the same time.
4. Make sure that you can pull the saw chain around
freely by hand and that it does not hang from the
guide bar.
1435 - 001 - 11.06.2020 Repair instructions - 13
To Next Page
Loading...
