5.6 Front handguard
5.6.1 To remove and install the front handguard
1. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
15
.
2. Remove the screw.
3. Carefully turn the front handguard to remove it from
the crankcase half.
4. Install in the opposite sequence.
5.7 Motor and control unit
5.7.1 To remove the motor, control unit and battery
connector
CAUTION:
Do not pull the cables.
1. Remove the drive sprocket cover. Refer to
Drive
sprocket and guide bar on page 11
.
2. Remove the drive sprocket. Refer to
To remove and
install the drive sprocket on page 11
.
3. Remove the brake drum. Refer to
To remove and
install the brake drum on page 12
.
4. Remove the worm gear. Refer to
To remove and
install the worm gear on page 12
.
5. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
15
.
6. Disassemble the power trigger. Refer to
Power
trigger on page 16
.
7. Remove the user interface. Refer to
User interface
on page 23
.
8. Make a note of how the cables and parts are
installed.
9. Remove the 2 screws on the battery connector.
10. Remove the 3 screws and the motor unit.
20 - Repair instructions 1435 - 001 - 11.06.2020
To Next Page
Loading...
