Husqvarna 340i - User Interface

5.8 User interface
5.8.1 To remove and install the digital user
interface
1. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
15 .
2. Disassemble the power trigger and the power trigger
lockout. Refer to To disassemble the power trigger
(digital user interface) on page 16 .
3. Pull out the airflow cover and the digital user
interface.
4. Disconnect the digital user interface.
5. Push in the clips and pull out the frame (A) of the
digital user interface.
6. Remove the digital user interface (B).
7. Install in the opposite sequence. Make sure that the
digital user interface attaches to the correct positions
in the crankcase when you install it.
5.8.2 To remove and install the mechanical user
interface
1. Disassemble the crankcase. Refer to To
disassemble and assemble the crankcase on page
15
.
2. Disassemble the power trigger and the power trigger
lockout. Refer to To disassemble the power trigger
(mechanical user interface) on page 18 .
3. Pull out the airflow cover and mechanical user
interface.
1435 - 001 - 11.06.2020 Repair instructions - 23