Husqvarna 340i - Cutting Techniques; General Cutting Techniques

7. Make sure that the edges of the power trigger and
the power trigger lockout are in the correct positions.
8. Assemble the crankcase. Refer to To disassemble
and assemble the crankcase on page 15 .
5.5.3 To disassemble the power trigger
(mechanical user interface)
1. Disassemble the crankcase. Refer to To
disassemble and assemble the crankcase on page
15 .
2. Make a note of how the inner parts of the power
trigger handle are installed.
3. Remove the power trigger lockout.
4. Make sure that the power trigger lockout has no
defects. Replace the power trigger lockout if it has
defects.
5. Remove the power trigger.
6. Pull out the recoil spring from the power trigger.
7. Make sure that there is tension in the recoil spring.
Replace the recoil spring if it is necessary.
8. Remove the main switch piston (A).
B
A
9. Pull out the main switch (B) and disconnect it.
18 - Repair instructions 1435 - 001 - 11.06.2020