4. Connect the user interface connector to the control
unit.
5. Connect the connector for the chain brake sensor
(A).
6. Put the motor (B), the control unit (C), the battery
connector (D) and the wire harness (E) into the
crankcase half.
7. Make sure that the connection points on the wire
harness are in the correct positions.
CAUTION: Make sure that the wire harness
and the motor cable holder do not touch the
fan.
8. Hold the battery connector in position and install the
2 screws.
9. Hold the motor in position and install the 3 screws.
10. Install the user interface. Refer to
User interface on
page 23
.
11. Assemble the power trigger. Refer to
Power trigger
on page 16
.
12. Assemble the crankcase. Refer to
To disassemble
and assemble the crankcase on page 15
.
CAUTION: Make sure that all cables and
parts are installed correctly before you
assemble the crankcase.
13. Install the worm gear. Refer to
To remove and install
the worm gear on page 12
.
14. Install the brake drum. Refer to
To remove and
install the brake drum on page 12
.
15. Install the drive sprocket. Refer to
To remove and
install the drive sprocket on page 11
.
16. Install the drive sprocket cover. Refer to
Drive
sprocket and guide bar on page 11
.
22 - Repair instructions 1435 - 001 - 11.06.2020
To Next Page
Loading...
