English – 63
Cleaning and Inspection
Assembly
Fit the generator if the saw is fitted with
handle heating.
Tighten the bolts to 4 Nm and lock using
Loctite.
Fit the cable to the actual contact on the
saw. Adjust the length of the cable by
knotting it.
• Replace the flywheel washer and nut.
Tightening torque, see "Service data".
• Remove the piston stop.
• Fit the ignition module
without tightening the
screws.
• Turn the flywheel so that its
magnet is beside the
ignition module.
ELECTRICAL SYSTEM
Clean all parts, especially the flywheel and
shaft taper.
Check that the flywheel is not cracked or
damaged in any other way.
Place the flywheel on the crankshaft. Rotate
gently until the flywheel's key mates in the
keyway on the shaft
Continue
assembly on
next page.
Eng, p 40-82 96-09-13, 10.2263
To Next Page
Loading...
