Husqvarna 440 e-series - TECHNICAL DATA; Recommended original and replacement bar and chain combinations; Saw chain filing and file gauges

32 – English
TECHNICAL DATA
1153159-95 Rev.2 2010-04-08
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw models 440e TrioBrake and 445e
TrioBrake. The combinations of power head, bar and chain have been tested and found to be in accordance with the
kickback and vibration requirements of ANSI B175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
Bar and chain combinations
Chain saw models Husqvarna 440e TrioBrake and 445e TrioBrake met the kickback performance requirements of ANSI
B 175.1-2000 when tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is
also classified as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B
175.1-2000. We recommend to use only the listed combinations of bars and chains for chain saw models Husqvarna
440e TrioBrake and 445e TrioBrake. Other chain saw models may not meet the kickback requirements when equipped
with the listed bar and chain combinations.
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below.
Saw chain filing and file gauges
Model:
Bar Chain
Length, inch Pitch, inch Gauge, mm
Max. nose
radius
Type
Length, drive
links (no.)
440e
TrioBrake,
445e
TrioBrake
13 0,325
1,3
10T
Husqvarna H30
56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
445e
TrioBrake
20 0,325 10T 78
13 0,325
1,5
10T
Husqvarna H25
56
15 0,325 10T 64
16 0,325 10T 66
18 0,325 10T 72
20 0,325 12T 78
0,050"/1,3 mm H30 H22 H23
0,058"/1,5 mm - H25 H21
440e TrioBrake
445e TrioBrake
445e TrioBrake