Husqvarna 450e II - Table of Contents; Contents

CONTENTS
8 – English
Contents
KEY TO SYMBOLS
Symbols on the machine: ...................................... 7
Symbols in the operator’s manual: ........................ 7
CONTENTS
Contents ............................................................... 8
INTR ODUCTION
Dear Customer , ..................................................... 9
WHA T IS WHAT?
What is what on the chain sa w? ........................... 9
GENERAL SAFETY PRECA UTIONS
Bef ore using a new chain saw .............................. 10
Important .............................................................. 11
Always use common sense .................................. 11
Personal protective equipment ............................. 11
Machine ′ s safety equipment ................................. 11
Cutting equipment ................................................. 13
ASSEMBL Y
Fitting the bar and chain ....................................... 18
FUEL HANDLING
Fuel ....................................................................... 19
Fueling .................................................................. 20
Fuel safety ............................................................ 20
ST ARTING AND STOPPING
Star ting and stopping ............................................ 21
W ORKING TECHNIQUES
Bef ore use: ............................................................ 22
General working instructions ................................ 22
How to avoid kickback ........................................... 25
MAINTENANCE
Gener al ................................................................. 26
Carburettor adjustment ......................................... 26
Checking, maintaining and servicing chain saw
safety equipment ..................................................
26
Muffler ................................................................... 27
Starter housing ..................................................... 27
Air filter .................................................................. 28
Spark plug ............................................................. 28
Needle bearing lubrication .................................... 28
Cooling system ..................................................... 28
”Air Injection” centrifugal cleaning ......................... 29
Winter use ............................................................. 29
Maintenance schedule .......................................... 30
TECHNICAL D ATA
T echnical data ...................................................... 31
Recommended cutting equipment ....................... 32
Filing equipment and filing angles ........................ 33
EC Declaration of Conformity ............................... 33