How to fix a Husqvarna 530iP4 Pole Saw that does not start?
If your Husqvarna Pole Saw does not start, it might be due to dirt in the battery connectors. Clean the battery connectors with compressed air or a soft brush to resolve this issue.
What to do if the red error LED flashes on my Husqvarna 530iP4?
If the red error LED flashes on your Husqvarna Pole Saw, it could be due to several reasons. One cause is overload, which means the cutting attachment is blocked. To solve this, stop the product, remove the battery, clean the cutting attachment, and loosen the chain. Another reason could be temperature deviation, in which case you should let the product cool down. It can also happen if the power trigger and the start button are pushed at the same time. In this case, release the power trigger and push the start button.
Why is the error LED flashing on my Husqvarna Pole Saw?
The error LED on your Husqvarna Pole Saw might be flashing because the battery is discharged. To fix this, charge the battery. Another possible cause is temperature deviation. Make sure to use the battery in surroundings where temperatures are between -10°C (14°F) and 40°C (104°F).
Why is the green start LED flashing on my Husqvarna 530iP4 Pole Saw?
The green start LED flashes on your Husqvarna Pole Saw because of low battery voltage. To resolve this, charge the battery.
Why is the green activate LED flashing on my Husqvarna 530iP4 Pole Saw?
The green activate LED flashes on your Husqvarna Pole Saw because of low battery voltage. To solve this, charge the battery.
General| Battery Voltage | 36 V |
|---|---|
| Power Source | Battery |
| Chain Pitch | 1/4" |
| Tube material | Aluminum |
| Battery Compatibility | Husqvarna Battery System |
| Chain Gauge | 1.1 mm |
| Extension Pole Length | Not extendable |
To Next Page
