Husqvarna 545 TrioBrake - Assembling the Chain Brake

18 - English
6.2 Assembling the chain brake
1
Screw the knee oint and the brake band together
(see gure 5) using a tightening torque of 1-1.5
m. Place the knee oint with the tted chain brake
band in the opening in the clutch cover. The space
for the spring in the cover must be lubricated with
grease. See gure 6.
2
Compress the spring with a wide screwdriver and
press it down with your thumb. See gure 7.
3
Fit the cover over the brake spring using 1-1.5 m
tightening torque. See gure 8.
WARNING!
Exercise care to ensure the spring
does not fly out and cause personal
injury. Wear protective goggles.
4
Tighten the brake by using the saws hand guard
as a tool. esh with the brake and tighten clock-
wise until the brake is in the off position. See
gure 9.
5
TE ake sure the bushings in the kickback
guards attachments are kept in place from the
inside. See gure 9.
Screw the kickback guard in place and put the
rocket in position. Position the spring () in the
plastic housing (C) (see gure 10) and press the
spring against the rocker and then press the plastic
housing into its groove. Tighten the chain guide
plate in place.
Fit the
• The bar
• The chain
• The clutch cover
• The cylinder cover
Safety equipment
Fig 6
Fig 7
Fig 8
Fig 9
A
B
C
Fig 10