Husqvarna 545 TrioBrake - Ismantling the Right-Hand Brake Trigger

English - 19
NOTE!
After repairing, the chain brake must be in-
spected in line with the instruction below.
Functional inspection:
o not turn on the motor when carrying out this
inspection.
ar length eight
38 cm15 50 cm20
• old the chain saw over a stable surface. The
distance between the bar and the surface is
shown in the table above.
• Let go of the front handle and let the chain saw
drop toward the surface underneath.
• When the bar hits the surface the chain brake
must trigger.
Safety equipment
Fig 11
6.3 Dismantling the right-hand brake
trigger
(545 TrioBrake, 550 XP TrioBrake,
550 XPG TrioBrake)
1
Release the brake by moving the front hand guard
towards the front handle. Loosen the bar nuts and
remove the clutch cover, bar and chain, see g. 1.
2
Loosen the screws  and remove the front handle,
see g. 2.
D
D
D
D
D
Fig 1
Fig 2