Husqvarna 545 TrioBrake - Page 41

English - 41
Repair Instructions
4. Assemble needle valve  with lever arm ,
shaft L and spring R, and tighten screw P.
(Fit the epansion washer). See gure 40.
5. Check using a ruler or the like that the lever is
level with the assembly plane on the cover.
If necessary, the lever arm can be bent, see
gure 41.
7. Fit gasket , the control membrane  and the
pump cover . See gure 42.
8. Carry out a pressure test.
Fig 41
Fig 42
K
J
H
Fig 40