EasyManua.ls Logo

Husqvarna 562XP Mark II - Page 24

Husqvarna 562XP Mark II
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To do a check of the vibration damping system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Refer to
Product overview on page 2
for information
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
2. Push the start/stop switch down to the STOP
position. The engine must stop.
Your product has the function that adjusts the carburetor
automatically, which gives the best possible adjustment.
lets the engine adapt to weather conditions, altitude,
gasoline and the type of two-stroke oil.
CAUTION: If does not work correctly,
speak to your servicing dealer. The product
adjusts correctly after some fuelings.
To do a check of the muffler
WARNING:
A used muffler/spark
arrester and spark arrester mounting
face may contain deposits of combustion
particles on the surfaces that may be
carcinogenic. To avoid skin contact and
inhalation of such particles when cleaning
and/or servicing the spark arrester, make
sure you always:
wear gloves;
clean and/or servicing in an area with
good air flow;
do not use pressurized air to clean the
spark arrester screen;
use a steel brush and brush away from
your body when cleaning the spark
arrester screen.
WARNING: Do not use a product that
has a damaged muffler or a muffler that is in
bad condition.
WARNING: Do not use a product if
the spark arrester screen on the muffler is
missing or damaged.
1. Examine the muffler for damages.
2. Make sure that the muffler is correctly attached to
the product.
Note: Do not remove the muffler from the product.
3. If your product has a special spark arrester screen,
clean the spark arrester screen weekly.
4. Replace a damaged spark arrester screen.
CAUTION:
If the spark arrester screen
is blocked the product becomes too hot
and this causes damage to the cylinder and
piston.
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing.
24
2053 - 001 - 18.04.2023

Related product manuals