Husqvarna 562XP Mark II - Filing Equipment & Angles

Approved cutting equipment for Husqvarna 562 XP Mark II, 562 XPG Mark II:
Guide bar Saw chain
Length, in/cm Pitch, in Gauge, in/mm Max. nose ra-
dius
Type Length, drive
links (no.)
Low kickback
20/50 3/8 0.060/1.6 11T Husqvarna
H83
72
24/60 11T or 34 mm 84
28/70 11T 92
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain.
A Husqvarna file gauge makes sure that you get the
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to www.husqvarna.com for more
information.
C85S 4.8 mm / 3.16 in 587 80 91-02
0.65 mm / 0.025
in
30° 60°
C83S 4.8 mm / 3/16 in 587 80 91-02
0.025 mm / 0.65
in
30° 60°
C85, C83 5.5 mm / 7/32 in 586 93 86-02
0.025 in / 0.65
mm
30° 60°
H83, C83SK
To sharpen the square ground chain professional knowledge and special tools are necessary.
We recommend to let you Husqvarna servicing dealer sharpen the square ground chain.
36 2053 - 001 - 18.04.2023