OPERATION
20 - Husqvarna
The neutral locks for the drive levers should be in •
locked position.
Before Starting
Read the sections on Safety and Controls before •
starting the machine.
Perform the daily maintenance before starting (see •
Maintenance Schedule).
Check that there is sufcient fuel in the fuel tank.•
The following conditions must be fullled before the
engine can be started:
The control for engaging the blades must be in •
disengaged (down) position.
The speed control lever must be in the start •
position.
8062-003
Neutral lock
8062-010
Starting position
WARNING!
Do not operate the mower if the
interlock safety system allows
operation or starting in any unsafe
condition.
WARNING!
Be thoroughly familiar with control
operation and function before using
the mower.
To Next Page
Loading...
