Husqvarna 966947005 - Fuel Filter Replacement

MAINTENANCE
Husqvarna-33
Replacing the Fuel Filter
Replace the line-mounted fuel lter every 100 hours
(once per season) or more regularly if it is clogged.
To replace the lter:
Move the hose clamps away from the lter. Use 1.
at-nosed pliers.
Pull the lter loose from the hose ends.2.
Push the new lter into the hose ends. Position the 3.
lter with the “FLOW” arrow pointing up toward the
fuel pump. If necessary, a soap solution can be
applied to the lter ends to ease mounting.
Move the hose clamps back toward the lter.4.
8011-783
Check and clean the cooling air intake
8062-030
Remove the paper lter
Remove the wing nuts for the air lter and remove 1.
the paper lter.
Tap the paper lter against a xed surface to 1.
remove dust. If the paper lter is still dirty, it must
be replaced.
To ret - check that the seal on the bottom of the 2.
paper lter is whole and not compressed at.
Mount the paper lter in the air lter housing and 3.
tighten the wing nuts.
Ret the prelter on the paper lter.4.
Replace the cowling over the air lter housing. Do 5.
not over tighten the plastic fastener.
8062-031
Remove dust