Husqvarna 967 08 27-15 User Manual (English)

Questions and Answers:

K
Kathleen MartinezAug 12, 2025
Why my Husqvarna Chainsaw engine does not start?
- L
  Lawrence CarterAug 12, 2025
  Several issues can prevent your Husqvarna Chainsaw engine from starting. It could be due to blocked starter pawls (adjust or replace them), incorrect fuel type (drain the tank and refill with the correct fuel), chain oil in the fuel tank (contact your dealer if you've tried starting it; otherwise, drain the tank), a dirty or wet spark plug (ensure it's dry and clean), an incorrect electrode gap (clean the spark plug and ensure the gap and plug type are correct), a loose spark plug (tighten it), or a flooded engine from repeated starts with full choke (remove and clean the spark plug, lay the chainsaw on its side with the spark plug hole facing away, pull the starter rope 6-8 times, then reassemble the spark plug and try starting).
P
Priscilla WoodAug 19, 2025
What to do if Husqvarna Chainsaw engine is flooded?
- G
  garywaltersAug 19, 2025
  If your Husqvarna Chainsaw engine is flooded due to repeated starts with full choke after ignition, remove and clean the spark plug. Put the chainsaw on its side with the spark plug hole away from you. Pull the starter rope handle 6-8 times. Assemble the spark plug and start the chainsaw.
M
Melissa HernandezAug 27, 2025
What to do if my Husqvarna 967 08 27-15 Chainsaw starts but stops immediately?
- B
  Brittany BrooksAug 27, 2025
  If your Husqvarna Chainsaw starts and then stops, it could be due to several reasons. The fuel type might be incorrect, in which case you should drain the tank and fill it with the correct fuel. Alternatively, the air filter could be clogged (clean or replace it), or the fuel filter might be clogged (replace the fuel filter). If the idle speed is not correct, you should speak to your servicing dealer.
K
Karen WillisSep 3, 2025
What to do if Husqvarna 967 08 27-15 fuel tank is filled with chain oil?
- C
  Christian ShermanSep 3, 2025
  If the fuel tank of your Husqvarna Chainsaw is filled with chain oil and you have tried to start the chainsaw, speak to your servicing dealer. If you have not tried to start the chainsaw, drain the fuel tank.