WARNING: Do not use a product if the
spark arrestor mesh on the muffler is
missing or defective.
1. Examine the muffler for damages and defects.
2. Make sure that the muffler is correctly attached to
the product.
3. If your product has a special spark arrestor mesh,
clean the spark arrestor mesh weekly.
4. Replace a damaged spark arrestor mesh.
CAUTION:
If the spark arrestor mesh is
blocked the product becomes too hot and
this causes damage to the cylinder and
piston.
Carburetor adjustment
Because of environmental and emissions laws, your
product has adjustment limitations on the carburetor
adjuster screws. This decreases the harmful exhaust
fumes from your product. You can only turn the
adjustment screws maximum ½ turn.
Basic adjustments and run-in
The basic carburetor adjustments are done at the
factory. For the recommended idle speed, refer to
Technical data on page 33
.
CAUTION: Do not operate the product
at too high speed during the first 10 hours of
operation.
CAUTION: If the saw chain rotates at
idle speed, turn the idle speed screw
counterclockwise until the saw chain stops.
To adjust the low speed needle (L)
• Turn the low speed needle clockwise until stop.
Note:
If the product has a bad acceleration
capacity or if the idle speed is not correct, turn the
low speed needle counterclockwise. Turn the low
speed needle until the acceleration capacity and idle
speed is correct.
To adjust the idle speed screw (T)
1. Start the product.
2. Turn the idle speed screw clockwise until the saw
chain starts to rotate.
3. Turn the idle speed screw counterclockwise until the
saw chain stops.
Note:
The idle speed is correctly adjusted when the
engine runs correctly in all positions. The idle speed
must also be safely below the speed at which the saw
chain starts to rotate.
WARNING: If the saw chain does not
stop when you turn the idle speed screw,
speak to your servicing dealer. Do not use
the product until it is correctly adjusted.
24 592 - 002 - 30.11.2021
To Next Page
Loading...
