3
9. Remove the bolt from center of clutch and remove the clutch.
10. Install new clutch aligning the keyway and also align the field restraint (figure 7).
Figure 7 (field restraint
)
11. Re-install belts on the primary drive, installing the back belt first.
12. Re-install the clutch wires, there is no polarity so either wire can be connected to either terminal.
13. Re-install the mule belt on the pulleys and jackshaft. Verify the belt is on the lower pulley on the rear of
the deck (figure 8).
Figure 8
14. Raise the left side
idler (figure 9) with a 2x4 or similar lever to raise the idler and release tension on the
mule belt. With tension removed, you can reposition the fixed idler loosened in step 7. Using the mark
you made try to reposition to its previous location. It will be close to level with the opposite side pulley
when the finished.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
