EasyManua.ls Logo

Husqvarna FE 350 EU - User Manual

Husqvarna FE 350 EU
117 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER'S MANUAL 2014
FE 350 EU
FE 350 AUS
FE 350 USA
Art. no. 3402007en

Table of Contents

Questions and Answers

  • O
    othompsonAug 16, 2025
    Why does my Husqvarna FE 350 EU Motorcycle have high oil consumption?
    • P
      Patrick EstradaAug 17, 2025
      High oil consumption in your Husqvarna Motorcycle can be attributed to a few reasons. Check if the engine vent hose is bent, and if so, route it without bends or replace it. An engine oil level that is too high can also cause this, so check and adjust the level. If the engine oil is too thin, change the engine oil and oil filter, and clean the oil screen. Lastly, worn piston and cylinder can lead to high oil consumption, so measure the piston/cylinder mounting clearance.
  • R
    Robert ConradAug 19, 2025
    What to do if my Husqvarna FE 350 EU engine won't crank with the electric starter?
    • H
      hjonesAug 19, 2025
      If your Husqvarna Motorcycle engine won't crank, it could be due to several reasons. You may not be following the correct start procedure. The battery might be discharged, requiring a charge. The main fuse could be blown, in which case you should replace it. Alternatively, the starter relay or the starter motor itself could be defective and require a check.
  • H
    Heidi AshleyAug 22, 2025
    Why my Husqvarna Motorcycle engine turns over but won't start?
    • S
      Scott MartinezAug 22, 2025
      If your Husqvarna Motorcycle engine turns over but doesn't start, several factors could be at play. Ensure you're following the correct start procedure. Check that the fuel hose connection is properly joined. A blown fuse (Fuse 1 or Fuse 2) could also be the culprit, so replace them if necessary. Other potential issues include an incorrectly set idle speed that requires adjustment, a spark plug that's oily or wet (clean, dry, or replace it), an improper spark plug gap (adjust to 0.8 mm), a defective ignition system (check it), a short-circuit in the wiring harness (inspect for frayed cables), or a defect in the fuel injection system (read out the fault memory using the Husqvarna diagnostics tool).
  • L
    Leslie WeberAug 25, 2025
    Why does my Husqvarna FE 350 EU engine have so little power?
    • B
      Brent WyattAug 26, 2025
      A lack of power in your Husqvarna Motorcycle engine can stem from several causes. The air filter might be heavily contaminated, so clean the air filter and air filter box. The fuel filter or fuel screen could be very dirty, requiring a change. A defect in the fuel injection system could also be the reason, requiring a diagnostic tool. Check for leaks or deformation in the exhaust system, and consider changing the glass fiber yarn filling in the main silencer. Also, check if the valve clearance is too little and adjust it. Finally, a defective ignition system can cause this problem, so check the ignition coil, spark plug connector and the stator winding of the alternator.
  • S
    Shane SmithAug 27, 2025
    What causes my Husqvarna Motorcycle engine to overheat?
    • D
      David NormanAug 28, 2025
      Several issues can cause your Husqvarna Motorcycle engine to overheat. Foam formation in the cooling system may be the cause, so drain and refill the coolant. A bent radiator hose should be replaced. A defective thermostat should be checked. Also, a defect in the radiator fan system can lead to overheating, so check the radiator fan fuse and the radiator fan itself.
  • M
    Mr. Edward AndrewsAug 30, 2025
    Why my Husqvarna Motorcycle engine does not speed up?
    • D
      Denise Green DDSAug 30, 2025
      If your Husqvarna Motorcycle engine does not speed up, it could be due to a defect in the fuel injection system, so read out the fault memory using the Husqvarna diagnostics tool. Alternatively, the ignition system may be defective, so check the ignition coil, the spark plug connector and the stator winding of the alternator.
  • S
    Stephen ObrienSep 2, 2025
    What to do if my Husqvarna Motorcycle engine dies during the trip?
    • C
      Casey BairdSep 2, 2025
      If your Husqvarna Motorcycle engine dies during a trip, first ensure you have enough fuel and refuel if necessary. A blown fuse (Fuse 1 or Fuse 2) could also be the problem, so replace the fuses. Check the coolant level and inspect the cooling system for leaks. Insufficient airflow can also cause the engine to die, so switch off the engine when stationary.
  • J
    Joseph StokesSep 4, 2025
    Why is my Husqvarna FE 350 EU Motorcycle battery discharged?
    • R
      Robert MillerSep 5, 2025
      A discharged battery on your Husqvarna Motorcycle can occur if the alternator is not charging the battery, so check the charging voltage and the stator winding of the alternator. Another possibility is an undesired power consumer draining the battery, so check the closed current.
  • H
    hbaldwinSep 7, 2025
    Why are the speedometer values (time, stop watch, lap times) deleted on my Husqvarna FE 350 EU?
    • K
      Kathleen ReynoldsSep 7, 2025
      The speedometer values might be deleted because the battery in the speedometer is discharged. Change the speedometer battery.
  • M
    Mrs. Rebecca Williams DVMSep 10, 2025
    Why are the high beam, low beam, parking light, tail light, and license plate lamp not working on my Husqvarna FE 350 EU?
    • D
      duncanlaurenSep 12, 2025
      If the high beam, low beam, parking light, tail light, and license plate lamp are not working on your Husqvarna Motorcycle, it is likely due to a blown fuse 3. Replace the fuses of individual power consumers.

Summary

Serial Number Locations

5.1 Chassis number

Details the location of the chassis number.

5.2 Type label (FE 350 EU, FE 350 AUS)

Shows the location of the type label on the steering head.

5.4 Engine number

Shows where the engine number is stamped.

Handlebar and Basic Controls

6.4 Kill switch (FE 350 EU, FE 350 AUS)

Explains the kill switch operation.

6.5 Kill switch (FE 350 USA)

Initial Use Safety Advice

8.1 Advice on first use

Important safety advice and warnings for the first use of the vehicle.

Pre-Ride Checks and Maintenance

9.1 Checks and maintenance work when preparing for use

Covers essential checks and maintenance before riding the vehicle.

Chassis Tuning - Basic Settings & Shock Damping

11.1 Checking the basic chassis setting with the riders weight

Covers basic chassis settings and rider weight adjustment.

11.2 Compression damping of shock absorber

Explains high-speed and low-speed compression damping.

11.3 Adjusting the low-speed compression damping of the shock absorber

Procedure for adjusting low-speed compression damping.

Hand Brake Lever Checks and Adjustments

13.1 Checking free travel of hand brake lever

Covers checking free travel of the hand brake lever.

13.2 Adjusting free travel of hand brake lever (FE 350 EU, FE 350 AUS)

13.3 Adjusting the basic position of the hand brake lever (FE 350 USA)

Engine Service - Fuel Screen & Oil Level

18.1 Changing the fuel screen

Steps for changing the fuel screen.

18.2 Checking the engine oil level

Procedure for checking the engine oil level.

Husqvarna FE 350 EU Specifications

General IconGeneral
BrandHusqvarna
ModelFE 350 EU
CategoryMotorcycle
LanguageEnglish

Related product manuals