Why did my Husqvarna FE 501 Motorcycle speedometer reset?
If the speedometer values (time, stop watch, lap times) are deleted on your Husqvarna Motorcycle, it's likely that the battery in the speedometer is discharged.
General| Engine Type | Single cylinder, 4-stroke |
|---|---|
| Bore x Stroke | 95 mm x 72 mm |
| Compression Ratio | 12.75:1 |
| Starter | Electric starter |
| Transmission | 6-speed |
| Front Suspension | WP XPLOR-USD, Ø 48 mm |
| Fuel Tank Capacity | 8.5 liters |
| Ground Clearance | 370 mm |
| Seat Height | 950 mm |
| Weight (without fuel) | 106.5 kg |
| Fuel System | Keihin EFI, throttle body 42 mm |
| Rear Suspension | WP XACT shock absorber with linkage |
| Front Brake | 260 mm disc |
| Rear Brake | 220 mm disc |
| ABS | No |
| Displacement | 510.9 cm³ |
Details safe operating practices and the importance of protective gear.
Essential guidance before the first ride and engine running-in procedures.
Procedures for pre-ride checks and starting the engine.
Guidance on gear shifting, braking techniques, and stopping the vehicle.
List of maintenance tasks required at specific operating hours.
List of recommended maintenance tasks for various intervals.
Adjusting suspension settings based on rider weight.
Procedures for adjusting low-speed and high-speed compression damping.
Adjusting rebound damping and checking/adjusting static and riding sag.
Adjusting fork compression, rebound damping, and spring preload.
Checking/adding front brake fluid and changing front brake linings.
Checking/adding rear brake fluid and changing rear brake linings.
Checking tire condition, wear, age, and setting air pressure.
Procedures for checking coolant level and antifreeze protection.
Steps for draining and refilling the motorcycle's coolant.
How to change the characteristic map of the throttle response.
Procedures for changing engine mapping and adjusting idle speed.
Teaching throttle valve position and adjusting shift lever position.
Procedures for changing fuel screen and checking engine oil level.
Step-by-step guide for changing engine oil and oil filter.
Procedure for adding engine oil to the correct level.
Troubleshooting for engine starting problems and lack of power.
Diagnosing engine overheating and malfunction indicator lamp issues.
Troubleshooting high oil consumption, battery discharge, and speedometer data loss.
Detailed engine specifications and tightening torque values.
Fluid capacities and chassis dimensions and details.
Specifications for shock absorber and chassis tightening torques.
Details on recommended brake fluid and coolant types and standards.
To Next Page