To do a check of the machine stop button
1. Disconnect the product from the mains outlet.
2. Make sure that the cutting blade is slightly above the
ground.
3. Make sure that the cutting blade and the blade
flange are tightly attached and the blade guard is
correctly installed. Refer to
To install a cutting blade
on page 13
and
To install the blade guard on page
15
.
4. Connect the power plug of the product into the mains
outlet.
5. Turn the machine stop button (STOP) clockwise to
make sure that it is disengaged.
6. Push the ON/OFF button to "I" to start the product.
7. Push the machine stop button and make sure that
the motor stops.
8. Turn the machine stop button clockwise to
disengage.
Ground fault circuit interrupter
A ground fault circuit interrupter (GFCI) is a protection
for the operator if an electrical fault occurs.
WARNING: Always use the ground
fault circuit interrupter supplied with your
product.
10 1620 - 003 - 28.02.2022
To Next Page