Need help?Do you have a question about the Husqvarna K 750 and is the answer not in the manual?
General| Engine Power | 3.7 kW |
|---|---|
| Displacement | 73.5 cm³ |
| Weight | 10.5 kg |
| Max Blade Diameter | 350 mm |
| Max. Cutting Depth | 125 mm |
| Cutting diameter | 350 mm |
| Engine Type | 2-stroke |
| Engine | 2-stroke |
Provides an overview of the workshop manual's content and structure.
Details regarding the spare parts folder for the K750.
Introduces the K750's innovative technical features.
Explains the engine's dual charge technology, emissions, and performance benefits.
Details on reduced vibration levels and the new muffler design.
Visual guide identifying major external components of the K750.
Introduction to the process of breaking down the machine into basic modules.
Procedures for dismantling the starter and cutting arm.
Explains the three-step filtration process.
Instructions for cleaning and replacing filter stages.
Procedures for fuel filter replacement and fuel hose testing.
Isolating fuel leaks and servicing the tank venting system.
Functional tests for air vents, filters, and non-return valves.
Steps for removing and cleaning the carburettor unit.
Information on support inserts and replacing carburettor guides.
Identifying carburettor parts and servicing the air valve.
Testing carburettor functions and inspecting the needle valve.
Checking pump/measurement diaphragms and servicing the fuel strainer.
Checking valve axles and adjusting idle speed.
Explains valve function, dismantling, and leakage testing.
Detailed steps for performing a compression test on the cylinder.
Instructions for removing the cylinder from the engine block.
Procedures for piston dismantling, using tools, and removing circlips.
Instructions for gudgeon pin work and piston ring installation.
Wear limits for cylinder bore, piston, and piston ring grooves.
Identifying common piston damage like wear, dust, scoring, and overheating.
Correct assembly procedures, piston orientation, and lubrication.
Steps for testing crankcase seals and identifying leaks.
Tools and procedures for dismantling and assembling crankcase seals.
Tools and steps for splitting the crankcase and removing the crankshaft.
Procedures for removing and installing the main bearing from the crankshaft.
Steps for fitting the crankshaft and assembling crankcase halves.
Procedures for removing and refitting the clutch assembly.
Specifications for clutch engagement, shoes, and drum.
Procedures for servicing clutch springs and the support ring.
Instructions for replacing the needle bearing in the clutch drum.
Procedure for replacing the ball bearing in the clutch drum.
Procedures for taking apart the cutting head components.
Tools and steps for replacing the blade shaft bearing.
Procedures for removing the bearing unit and checking components.
Steps for assembling bearings and adjusting the axle.
Procedures for fitting the belt pulley and centre bush.
Explains the retarder's function and replacement.
Procedures for dismantling and assembling the centrifugal unit.
Checking the throttle lock and dismantling handle controls.
Tools for ignition system, piston service, and flywheel removal.
Tools for crankcase splitting, clutch work, and bearing replacement.
To Next Page