Problem Possible cause Solution
There is too much vibration in the
handle.
A blade is loose or not balanced. Tighten the blade bolts. Replace the blades if
there are damages.
A blade is bent. Replace the blades if there are damages.
The grass is not cut into mulch. The engine speed is too low. Move the throttle control to between ¾ and
full throttle.
The grass is wet. Do not operate the product when the grass is
wet. Wait until the grass is dry.
The grass is too high. Cut first with the cutting height set high. Low-
er the cutting height and cut again.
Cut only ½ of the cutting width at a time.
One or more of the blades are
not sufficiently sharp.
Let an approved service agent sharpen or re-
place the blades.
The grass is cut irregularly. The wheels are not in correct po-
sition.
Set the cutting height at the same level for all
4 wheels.
One or more of the blades are
not sufficiently sharp.
Sharpen or replace the blades.
The drive system does not oper-
ate correctly (LC 19SP)
The clutch wire must be adjus-
ted.
Adjust the clutch wire.
The drive belt is not sufficiently
tight or there is dirt on the pulleys
or drive belt.
Let an approved service agent do mainte-
nance on the drive system.
Transportation, storage and disposal
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
• Safely attach the product during transportation to
prevent damage and accidents.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the product in a dry and frost free area.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
Technical data
LC 18 LC 19 LC 19A LC 19AP LC 19SP
Engine
Brand Briggs & Strat-
ton
Briggs & Strat-
ton
Briggs & Strat-
ton
Briggs & Strat-
ton
Briggs & Strat-
ton
928 - 001 - 17.12.2018 13
To Next Page
Loading...
