To use the drive on the wheels
(LC 19SP)
• Push the drive bail in the direction of the handlebar.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm / 4 in.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product
• To stop the engine, move the throttle control to the
stop position.
• If the engine does not stop, disconnect the ignition
cable from the spark plug.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
Introduction
WARNING: Before you do maintenance,
you must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 5
.
Maintenance Daily Weekly Monthly
Do a general inspection X
Examine the oil level X
Clean the product X
Examine the cutting equipment X
Examine the cutting cover * X
928 - 001 - 17.12.2018 9
To Next Page
Loading...
Need help?
General
