English – 11
Repair instructions
4. Unscrew the three screws and lift out the engine.
5. Unclip the sleeves if necessary.
4.3 To remove the front axle
1. Remove the skid plate and disconnect the height
adjuster.
2. Remove the wheel and axis assembly
3. Remove the wheel caps. Remove the screw.
Remove and replace the bearings.
4.4 To remove the rear axle (with
drive)
The following procedures applies for both sides:
1. Remove the wheel caps.
2. Remove the wheel.
3. Remove the circlip using a circlip plier and remove
the pinion, washer and inner cirlip.
4. Remove the dust cover.
To Next Page
Loading...
