Husqvarna MZ54 - Engine Oil Change; Wheel and Deck Zerks

Wheel and Deck Zerks
Use only good quality bearing grease. Grease
from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Mount
Lubricate 3-4 strokes with a grease gun on each
set of wheel mounts.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
Lower the cutting deck completely.
If a grease gun without rubber hose is used, the
foot plate must be removed to access the center
spindle.
Lubricate with a grease gun, 2-3 strokes per
spindle.
Engine oil change
NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner’s manual
for the correct replacement oil and fi lter change
recommendations.
WARNING! The engine drain plug is near
to the muffl er. To prevent burns, the engine
should be shut off and allowed to cool slightly
so the engine is still warm but the adjacent
surfaces and oil are not.
1. Park on a level surface. Engage park brake.
2. Clean the dirt and debris from the area around
the oil fi ll cap.
3. Remove the cap/dipstick.
4. Find the drain hose at the right rear of the
engine. Place a suffi ciently sized container
under the end of the drain hose and remove
the oil drain plug.
5. Let the used oil fully drain from the engine.
6. Replace and tighten the drain hose plug.
7. Fill the engine with new oil to the bottom of
the fi ll tube threads. Check the level with the
dipstick.
8. Replace and tighten the oil fi ll cap when the
oil level is FULL.
9. To discard the used oil, refer to local disposal
regulations.
10. Refer to the Service Journal for oil checking
and changing intervals and change
recommendations.
30
LUBRICATION
2
3
4
5
16
14
13
12
11
10
9
8
7
1
6
15
Este manual del operador corresponde al
cortacésped Zero Turn de Husqvarna. El
cortacésped está equipado con un motor de
válvula superior de cuatro tiempos.
La transmisión del motor se hace mediante
bombas hidráulicas accionadas por correa.
Utilizando los controles de la dirección izquierdo
y derecho, se regula el caudal y, por lo tanto, el
sentido de marcha y la velocidad.
1. Palancas de movimiento
2. Freno de estacionamiento
3. Botón de seguimiento
4. Tapa del depósito de combustible
5. Corte de combustible
6. Palancas de hidrostática
7. Fusibles
8. Estrangulador
9. Interruptor de encendido
10. Medidor de servicio
11. Acelerador
12. Interruptor de la cuchilla
13. Palanca de asiento
14. Elevación del equipo
15. Pedal de equipo
51
CONTROLES