EasyManuals Logo

Husqvarna PW 235R User Manual

Husqvarna PW 235R
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8 – English
2.7 To disassemble/assemble the
motor cover
1. Put the product on the side and remove the 4 torx 20
screws.
2. Remove the wheel to remove the 5th screw.
3. Remove the cabinet. Take out the motor/pump unit.
The micro switch box can be removed by hand.
4. Install the motor/pump unit:
- Install the micro switch box by hand (alternatively
use a plastic hammer). Make sure you install it in the
correct position.
- Install the motor/pump unit inside the cabinet.
2.8 To disassemble/assemble the
start/stop valve
1. Assemble the start/stop valve, see gure below.
2. Use a special tool to remove the seat of the start/stop
valve. Use “Puller for valve seat M4” part number
592 94 50-01.
NOTE: The seat of the start/stop valve is no longer
usable after using the puller.
Repair instructions

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Husqvarna PW 235R and is the answer not in the manual?

Husqvarna PW 235R Specifications

General IconGeneral
BrandHusqvarna
ModelPW 235R
CategoryPressure Washer
LanguageEnglish

Related product manuals