6 Maintenance schedule for the service center
1. PREPARE THE PRODUCT First serv-
icing
Maintenance interval
in hours
50 100 200
Do a check of the battery. O
Do a check of the blades. O
Do a check of the belts and pulleys. O O
Do a check of the steering chain of the inner side of the frame tunnel. O
Do an inspection, lubricate and adjust all wires. O
Make sure that all screws and nuts are tightened with the correct torque. O
Lubricate the operators seat. O
Lubricate the wheels and blade bearings on the cutting deck. O O
Lubricate the pedals on the inner side of the frame tunnel. O
Lubricate the belt tensioner. O
2. ENGINE First serv-
icing
Maintenance interval
in hours
50 100 200
Do a check of the fuel hose. Replace if it is necessary. O
Replace the fuel filter. O
Replace the prefilter and paper filter in the air filter. Clean O
Clean the engine and the hydrostatic transmission. O
Do an inspection of the cooling fins on the hydrostatic transmission. O
Do a check of the muffler and the heat deflector. O O
Replace the engine oil. Refer to
Technical data on page 49
. O O
Replace the engine oil filter. O O
Replace the spark plug. O
Do a check of the battery and charge if it is necessary. O O
3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM First serv-
icing
Maintenance interval
in hours
50 100 200
Do a check of the oil in the transmission and fill if it is necessary. Refer to
To do
a check of the transmission oil level on page 11
.
O
Make sure that the tire pressure is correct. Refer to
Wheels on page 9
. O O
Examine and adjust the parking brake. O O
Replace the oil in the transmission. Refer to
To replace the oil in the transmission
on page 37
.
O O
14 - Maintenance schedule for the
service center
1592 - 002 - 11.02.2021
To Next Page
Loading...
Need help?
General
