3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM First
servicing
Maintenance interval
in hours
50 100 200
Do an inspection of and adjust the front and rear wheel rotation speed (only
AWD).
O O
Replace the transmission filter (only AWD). O O
Replace the spin on filter for the servo (if applicable). O O
Do a check of the cooling fan on the hydrostatic transmission. O O
Do a check of the oil in the transmission and fill if it is necessary. Refer to
To do
a check of the transmission oil level on page 27
.
O
Examine and adjust the parking brake. O O
Replace the oil in the transmission. Refer to
To do a check of the transmission
oil level on page 27
.
O O
4. CUTTING EQUIPMENT First
servicing
Maintenance interval
in hours
50 100 200
Clean the outer and inner surfaces of the cutting deck and the cutting deck cov-
ers.
O O
Do a check of and adjust the cutting height and pitch setting. O O
Examine the blades in the cutting deck, sharp and balance if needed. O
5. LAST INSPECTION AND DOCUMENTATION First
servicing
Maintenance interval
in hours
50 100 200
Do a check of and adjust the engine RPM. O O
Make sure that the product does not move in neutral position. O O
Do a check of the forward drive and the rearward drive on different speeds. O O
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Safety devices on the product on page 8
.
O O
Do an inspection of the collection system (if applicable). O O
To clean the product
CAUTION: Do not use a high-pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
1686 - 001 - 03.11.2021 17
To Next Page
Loading...
Need help?
General
