1. PREPARE THE PRODUCT First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the belts and pulleys. O O
Do a check of the steering chain of the inner side of the frame tunnel. O
Do an inspection, lubricate and adjust all wires. O
Make sure that the tire pressure is correct. Refer to
Tire pressure on page 22
. O O
Make sure that all screws and nuts are tightened with the correct torque. O
Lubricate the operators seat. O
Lubricate all chains. O
Lubricate the wheels and blade bearings on the cutting deck. O O
Lubricate the pedals on the inner side of the frame tunnel. O
Lubricate the belt tensioner. O
Remove the drive wheels and grease the axels. O
2. ENGINE First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the fuel hose. Replace if it is necessary. O
Replace the fuel filter. Refer to
To replace the fuel filter on page 19
. O
Replace the air filter. Refer to
To remove and install the air filter on page 20
. Clean O
Do an inspection of the cooling fins on the hydrostatic transmission. O
Clean the engine and the hydrostatic transmission. O
Do a check of the muffler and the heat deflector. O O
Replace the engine oil. Refer to
To replace the engine oil and oil filter on page
26
.
O
100
hours or
one (TN)
time each
year
Replace the engine oil filter. Refer to
To replace the engine oil and oil filter on
page 26
.
O O
Replace the spark plug. Refer to
To examine and replace a spark plug on page
20
.
O
Do a check on the lights (if applicable). O O
Update the firmware (if applicable). O O
Do a check of the battery and charge if it is necessary. O O
16 1686 - 001 - 03.11.2021
To Next Page
Loading...
