Need help?Do you have a question about the Husqvarna Rider 13C and is the answer not in the manual?
General| Engine Manufacturer | Briggs & Stratton |
|---|---|
| Engine Type | 4-stroke |
| Cylinder Displacement | 344 cm³ |
| Fuel Type | Gasoline |
| Transmission Type | Hydrostatic |
| Drive | Rear-wheel drive |
| Cutting Width | 85 cm |
| Cutting Methods | BioClip®/Rear discharge |
| Blades | 2 |
| Turning Radius | 30 cm |
| Cutting Height Min-Max | 25 mm |
General guidance for personnel using the workshop manual.
Warnings and precautions for specific hazardous materials and conditions.
Specifications for Rider models, including length, width, and weight.
Details on engine manufacturer, model, power, and fuel requirements.
Information on battery type, spark plug, and fuse specifications.
Manufacturer, oil type, and gear specifications for different models.
Torque specifications for various components and fasteners.
Specified control cable and component play tolerances.
Specifications for cutting widths and blade lengths.
Various checks and measurements for different models.
Steps for preparing the machine before customer delivery.
Maintenance schedule for different service intervals.
Detailed checklist of maintenance tasks and intervals.
Instructions for dealers on proper machine delivery and customer handover.
Procedures for handling and unpacking the machine from its packaging.
Steps for filling, charging, and installing the battery.
Fitting steering wheel, tow plate, checking oil, tyre pressure.
Procedures for test running the machine after assembly.
Adjusting engine speed and completing delivery paperwork.
Introduction to the Husqvarna Rider series, features, and articulation.
Locating and identifying machine and engine serial numbers.
Information on Briggs & Stratton engines used in the Riders.
Explanation of the articulated steering mechanism and turning radius.
Description of manual gearbox and hydrostatic transmission operation.
Overview of different front-mounted mowing deck options.
How the mowing deck lifting mechanism operates.
Description of how to adjust the cutting height.
Step-by-step guide for removing and installing the engine.
Procedures for steering wires, axle, and bearings.
Adjusting brake wire, gear control, and throttle.
Procedures for gearbox, hydrostatic transmission, and axles.
Adjusting ground pressure, parallelism, and cutting height.
Procedures for removing, replacing, and servicing blades.
Instructions for sharpening and balancing blades.
Wiring diagrams for Rider 11, 13C, 15C, and 16 models.
Procedures to verify the function of safety systems.
Details on seat, neutral position, and deck microswitches.
Information on the ignition system and main fuse.
To Next Page