What to do if turn signal, brake light, and horn are not functional on my Husqvarna Motorcycle?
If the turn signal, brake light, and horn on your Husqvarna Motorcycle are not working, it is likely due to a blown fuse. Specifically, check fuse 4 or 6 and replace them.
How to fix a non-functioning speedometer on my Husqvarna Motorcycle?
If the speedometer in the combination instrument of your Husqvarna Motorcycle is not functioning, the cause might be a damaged speedometer wiring harness or an oxidized plug-in connector. Inspect the wiring harness and the plug-in connector.
Why is my Husqvarna Motorcycle 12V battery discharged?
If the 12V battery of your Husqvarna Motorcycle is discharged, it could be due to several reasons. First, ensure that the ignition was switched off when the vehicle was parked; if not, charge the 12V battery. Another possible cause is that the 12V battery is not being charged by the alternator. In this case, check the charging voltage and the open-circuit current.
Why does the combination instrument show nothing on the display of my Husqvarna Motorcycle?
If the combination instrument on your Husqvarna Motorcycle display is blank, the issue is likely a blown fuse. Check fuse 2 or 7 and replace it.
What to do if time is not displayed correctly on my Husqvarna Motorcycle?
If the time is not displayed correctly on your Husqvarna Motorcycle, it may be due to a blown fuse. Check fuse 2 or 7 and replace them.
General| Torque | 12 Nm @ 7, 500 rpm |
|---|---|
| Transmission | 6-speed |
| Fuel System | Electronic Fuel Injection |
| Seat Height | 835 mm |
| Weight | 146 kg (without fuel) |
| Fuel Tank Capacity | 9.5 liters |
| Tires | Front: 110/70-17, Rear: 150/60-17 |
| Rear Suspension | WP APEX Monoshock |
| Bore x Stroke | 58 mm x 47.2 mm |
| Starter | Electric |
| Final Drive | Chain |
| Frame | Steel trellis frame |
| Engine | Single cylinder, 4-stroke, 125cc |
| Power | 15 hp |
| Brakes | Hydraulic disc brakes |
| Front Suspension | WP APEX 43 |
| Front Brake | 320 mm disc |
| Rear Brake | 230 mm disc |
| Wheelbase | 1357 mm |
Explains the meaning of symbols used in the manual.
Explains the typographical formats used in the document.
Defines the intended use and limitations of the vehicle.
Explains what constitutes misuse of the vehicle.
General advice for safe operation and reading instructions.
Explains risk levels and associated symbols.
Details warranty conditions and voiding factors.
Notes on fuel usage and environmental hazards.
Importance of regular service for optimal operation.
Identifies components on the front left view of the vehicle.
Identifies components on the rear right view of the vehicle.
Location of the vehicle identification number.
Location of the engine number.
Describes the clutch lever and its location.
Describes the hand brake lever and its function.
Describes the throttle grip and its location.
Identifies switches on the left handlebar.
Identifies switches on the right handlebar.
Location and states of the ignition and steering lock.
Steps to open the fuel tank filler cap.
Overview of the main instrument panel.
Explains the function of various indicator lamps.
Explains the tachometer, gear, speed, and other display areas.
How to adjust ABS modes.
Essential checks and advice before initial operation.
Guidelines for the engine running-in phase.
Pre-ride checks for roadworthiness.
Procedures and safety for starting the engine.
Correct use of front and rear brakes.
Lists maintenance tasks and their intervals.
How to adjust rear shock spring preload.
Step-by-step guide to adjust handlebar position.
Procedure for lifting the rear using a stand.
How to clean fork dust boots.
Steps to remove the passenger seat.
Steps to remove the left side cover.
Steps to install the license plate bracket.
Procedure for cleaning the drive chain.
Procedure for adjusting chain tension.
Explains the ABS system and its function.
Procedure for checking front brake fluid level.
Steps for adding front brake fluid.
How to check rear brake pad thickness.
Steps to remove the front wheel.
Steps to remove the rear wheel.
How to inspect tires for damage and wear.
Correct tire pressures for solo and passenger use.
Steps to safely remove the 12-V battery.
How to charge the 12-V battery safely.
Procedure for replacing the main fuse.
How to check and adjust headlight aim.
How to check coolant and antifreeze status.
Procedure for filling and bleeding the cooling system.
How to check clutch lever free play.
How to adjust the shift lever's resting position.
How to check the engine oil level.
Procedure for oil and filter change.
Guidelines for washing the motorcycle.
Winter care and protection measures.
Steps for preparing the motorcycle for storage.
Steps to take the motorcycle out of storage.
Lists engine specifications.
Chassis specifications including dimensions and weights.
Details on battery, fuses, and lighting.
Torque values for chassis fasteners.
Specifications and recommended brake fluid.
Coolant type and antifreeze protection guidelines.
Fuel type and ethanol content guidelines.
Recommended chain cleaner product.
Recommended motorcycle cleaning product.
Recommended universal oil spray.
Explains the JASO T903 MA2 motorcycle oil standard.
Explains SAE viscosity classification for oils.
To Next Page