Need help?Do you have a question about the Husqvarna TE 125 and is the answer not in the manual?
General| Engine Type | Single cylinder, 2-stroke |
|---|---|
| Displacement | 124.8 cc |
| Bore x Stroke | 54 mm x 54.5 mm |
| Ignition | Kokusan |
| Transmission | 6-speed |
| Rear Suspension | WP Monoshock |
| Front Tire | 90/90-21 |
| Cooling | Liquid cooled |
| Seat Height | 960 mm |
| Front Suspension | WP USD Ø 48 mm |
| Front Brake | 260 mm disc |
| Rear Brake | 220 mm disc |
| Rear Tire | 120/90-18 |
| Starter | Kickstarter |
Detailed technical data for the engine, including bore, stroke, and displacement.
Information on frame type, front fork, rear suspension, and wheel travel.
Identifies the placement of key electrical system components on the motorcycle.
Lists all fluid capacities for the motorcycle, such as fuel tank and oil.
Outlines essential vehicle configuration requirements for warranty validity.
Comprehensive technical specifications for the engine and its core systems.
General specifications for tightening standard fasteners, with torque values.
Specific torque values for various engine components during assembly.
Detailed steps for removing, checking, and installing the cylinder head.
Procedures for removing, checking, and installing the piston and cylinder assembly.
Steps for removing, checking, and installing the clutch components.
Procedures for crankshaft removal, inspection, and checking.
Recommended service intervals and lubrication tasks for the vehicle.
Step-by-step guide for checking and adjusting valve clearances.
Instructions for measuring engine compression pressure.
Guide for draining, replacing, and checking engine oil.
Information on thermostat removal, check, and installation.
Procedures for water pump removal, check, and assembly.
Method to test the thermostat's opening temperature for accuracy.
Steps to inspect and clean the carburettor and its components.
Guide for installing and adjusting the carburettor.
To Next Page