Husqvarna TS 142 - Page 12

4. Put the seat on the seat pan (B) and put the
middle plastic piece (C) into the middle slot
assembly hole (D).
5. Push the seat rearward until the 2 front plastic
pieces (E) are aligned with the front slot
assembly holes. Push down the seat to engage
the plastic pieces in the slots. Push the seat
rearward.
1
2
6. Fold the seat forward and install the 2 bolts (F)
and the 2 washers (G).
F
H
G
I
Note: Make sure that the 2 front plastic pieces
(H) are fully engaged in the seat pan.
Note: Make sure that the arrows on the 2
washers point up.
7. Remove the tape from the adjustment lever (I)
and discard the tape.
8. Do a check of the operator presence control.
Refer to
To do a check of the operator presence
control (OPC) on page 7
.
WARNING:
Do no operate the
product if the operator presence
control is defective.
To install the engine cover piece
1. Align the front tab on the engine cover piece with
the cut-out in the engine cover.
2. Align the rear tabs on the engine cover piece
with the cut-outs in the engine cover.
3. Push down the engine cover piece on the engine
cover.
To adjust the seat
1. Sit in the seat.
2. Lift up the seat adjustment lever (A).
A
3. Move the seat until it is in a position where you
can push the brake and clutch pedals down.
12
1934 - 005 - 20.10.2022