SERVICE AND ADJUSTMENTS
• ATTACH FRONT U NK (E) - Work from left side of trac-
tor, Insert rod end of link assembly through front hole
in tractor front suspension bracket (F),
• Insert end of link (E) into hole in front mower bracket
and secure with washer and retainer spring (J),
FIG. 18
ATTACH REAR LiFT LINKS (C) - Lift rear corner of
mower and position slot in link assembly over pin (D)
on rear mower bracket and secure with washer and
retainer spring,
%
33004
FiG. 20
• Hook end of clutch cable spring (Q) into hole in idler
arm (R),
• Push clutch cable housing guide (P) into bracket, slide
collar (L) onto guide and secure with retainer spring (K),
• Install belt on engine pulley (M), in belt keepers (G),
IMPORTANT: CHECK BELT FOR PROPER ROUTING
IN ALL MOWER PULLEY GROOVES,
• Raise attachment lift lever to highest position,
• If necessary, adjust gauge wheels before operating
mower as shown in the Operation section of this
manual,
%
FIG. 21
19
03042tex
To Next Page
Loading...
