EasyManua.ls Logo

Husqvarna YTH2246 - Engine Component Adjustments

Husqvarna YTH2246
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICE AND ADJUSTMENTS
TO REPLACE BATTERY TO REMOVE HOOD AND GREL ASSEMBLY
(See Fig. 30) (See Fig. 31)
WARNING: Do not short battery terminals
by allowing a wrench or any other object
to contact both terminals at the same time,
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc
Positive terminal must be connected first to prevent spark-
ing from accidental grounding,
Lift seat pan to raised position,
Disconnect BLACK battery cable first then RED
battery cable and carefully remove battery from tractor,
Install new battery with terminals in same position
as old battery,
First connect RED battery cable to positive (+)
terminal with hex bolt and keps nut as shown, Tighten
securely, Slide terminal cover over terminal
Connect BLACK grounding cable to negative (-)
terminal with remaining hex bolt and keps nut, Tighten
securely,
Raise hood.
Unsnap headlight wire connector,
Stand in front oftractor, Grasp hood at sides, tilt toward
engine and lift off of tractor,
To replace, reverse above procedure,
HEADLIGHT
WIRE
CONNECTOR
FiG. 31
Terminal
,Keps
Cover _Nut
"- Hex
Bolt
Positive
(Red)
Cable
Negative (Black)
Cable
FIG. 30
TO REPLACE HEADLIGHT BULB
Raise hood.
Pull bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill,
Close hood,
iNTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring. See electrical wiring diagram in the
Repair Parts section,
TO REPLACE FUSE
Replace with 20 amp automotive-type plug-in fuse, The
fuse holder is located behind the dash,
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and
adjustment should not be necessary, If adjustment is nec-
essary, see engine manual,
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and ad-
justment should not be necessary, If adjustment is neces-
sary, see engne manual,
TO ADJUST CARBURETOR
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your tractor to an authorized service center for repair
and/or adjustment,
23

Table of Contents

Related product manuals