Step 1: Make sure the aluminum
channel and end caps are installed.
Step 2: Use silicone lubricant to help
the bumper slide into the channel.
Installation (Cont'd)
Bumper Installation Instructions
Step 3: Starting on one end: while
inserting the bumper, push it up against
the end cap to prevent the bumper from
shrinking after installation (when it gets
cold).
Step 4: As you insert the bumper
into the channel with one hand, pull the
bumper toward you with the other to open
the inside lips. Slowly apply pressure by
rolling the bumper into the track.
9
To Next Page
Loading...
