Hussmann RL - Install RLT Solid End Assembly; Fasten and Wire RLT Solid End

P/N 0387152_H
14
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
RLT ONLY
8
Glass Ends Only
Glass end assemblies have
anti-sweat heaters. The heater
wiring must be connected to
the terminal block in the
wireway. Gain access to the
wireway as follows:
9
Fasten
End Assembly — 5
to merchandiser using
Cap Screw — 6.
After end assembly has been
tightened, insert Plug — 7
and Button — 8 as shown
in Figure 10.
Figure 10. Install Solid End Assembly
Route anti-sweat heater
wiring from end panel
through grommet into
raceway.
DO NOT damage wiring.