Belt replacement
Inspect the pump drive belts frequently for wear and
serviceability. Replace a belt that shows signs of severe
cuts, tears, separation, weather checking and cracking, or
burns caused by slipping. Slight raveling of belt covering
does not indicate failure, trim ravelings with a sharp knife.
WARNING: If the pump belt fails, loss of
control may occur when operating on a slope.
Inspect the belt pulley grooves and flanges for wear. A
new belt, or one in good condition, should never run against
the bottom of the groove. Replace the pulley when this is
the case, otherwise belt will lose power and slip excessively.
Never pry a belt to get it on a pulley as this will cut or
damage the fibers of the belt covering.
Keep oil and grease away from belts, and never use belt
dressings. Any of these will destroy the belt composition in
a very short time.
General engine maintenance
Detailed instructions and recommendations for break-in
and regular maintenance are specified in the Maintenance
Instructions section of the Ford or Kubota Owner’s manual.
Please refer to these manuals for engine servicing,
lubricating oil levels with quality and viscosity
recommendations, belt tensioning, etc. The engine warranty
is backed by Ford Motor Co. or Kubota, respectively.
Special attention should be paid to applicable data which
will not be duplicated here.
728444 Rev. 11/02
5-16
To Next Page
Loading...
Need help?
General
