REV F 5-2 604345
Uneven cutting height The blade(s) are not sharp Sharpen the blades
A cutting blade(s) is/are
bent
Install new cutting blade(s)
The deck is not level Level the deck per the
Deck leveling and height
adjustment section of the
General Service Manual
An anti-scalp wheel is not
set correctly
Adjust the height of the
anti-scalp wheel
The underside of the deck
is dirty
Clean the underside of the
deck
Tires improperly inflated Adjust air pressure to drive
tires 15 - 20 psi (103 - 138
KPa). Front tires 20 - 25 psi
(138 - 172 KPa)
A blade spindle is bent Contact your dealer
SYMPTOMS
PROBABLE
CAUSES
SUGGESTED
REMEDIES
To Next Page
Loading...
