3.6
CLEANLINESS
The heavy-duty design should endure heavy operating conditions and provide the customer with awless machine perfor-
mance. To extend good performance some care is required especially where cleanliness is concerned.
The following areas should be kept clean:
• Control console free of dirt and grease
• Door charts free of dirt and grease
• Wheel boxes free of chips
• Blade guides free of chips
• Out-feed tables free of chips
• A large chip build-up should be avoided in the base of the saw
NOTE: All parts must be cleaned before any repair service may be performed on them.
To Next Page
Loading...
Need help?
General
