HYDE QuickReach 28670 - Using the QuickReach with RVT Technology; Installing the QuickReach and RVT Spray Mounts; Removing the QuickReach and RVT Spray Mounts; Maintenance

This telescoping QuickReach
®
spray pole also accepts the HYDE
®
RVT
™
spray mount from
the HYDE
®
Advanced Spray System (Figure 5). This exibility enables you to use your
existing spray guns while you advance your spraying capability with Rapid Valve Transfer
™
(RVT
™
) technology.
HYDE
®
RVT
™
technology eliminates the weight of the spray gun at the top of the docking
station, reducing user fatigue and increasing control. RVT
™
technology also saves time,
enabling you to move between handheld and pole-mounted spraying quickly, without
depressurizing the system and tting a spray gun into a complicated gun adapter. You can
also change tips quickly without depressurizing to match the uid requirements for the
optimum spray pattern.
Using the QuickReach
®
with RVT™ Technology
Figure 5
RVT
™
Mount
After each use, wipe the QuickReach
®
spray pole and gun mount with a cloth dampened with water or mineral spirits.
Then wipe dry with a clean cloth.
NOTE: Do not immerse or soak any of the components in cleaning uids.
Check all screws and nuts for tightness.
Check that all components are properly positioned within their working range and that they are secured in place.
Maintenance
Installing the QuickReach
®
and RVT
™
Spray Mounts Removing the QuickReach
®
and RVT
™
Spray Mounts
1. Depress the locking lever on the
spray pole.
3. Fully insert the connector into the spray
pole and release the locking lever. Test
to be sure it is seated properly.
2. Align the hole on the RVT
™
spray
mount connector with the locking
lever on the spray pole.
1. Depress the locking lever on the
spray pole.
3. Release the locking lever.
2. Pull the RVT
™
spray mount from
the spray pole.
NOTE: You would only remove the mount if you were replacing
it or if you are switching to another HYDE
®
accessory.