To Next PageTo Next Page
Need help?Do you have a question about the Hydor ETH and is the answer not in the manual?
General| Type | External Inline Heater |
|---|---|
| Hose Diameter | 5/8" (16mm) |
| Wattage | 200W, 300W |
| Safety Features | Automatic shut-off |
| Temperature Range | 20-34°C (68-93°F) |
| Suitable for Aquariums | Freshwater and Marine |
| Voltage | 110-120V / 220-240V |
| Suitable For Aquarium Size | 200W: up to 200L, 300W: up to 300L |
Connects filter tubing to the heater unit.
Mounting point for the heater.
Shows water circulation direction.
Adjusts and sets water temperature.
Difference between water & room temperatures.
Critical: Heater must be installed vertically.
Always disconnect power before any work.
Ensure home voltage matches heater requirements.
Confirm home's breaker protection.
Position cable lower than socket to prevent water ingress.
Check if knob is set correctly.
Ensure heater is on and water circulates.
Ensure set temp vs room temp is within limits.
Ensure tank size matches heater capacity.
Confirm adequate flow and no blockages.
