To Next Page
B
Brandon MolinaNov 5, 2025
What to do if the Hydro Tek CP burner does not come on?
- SSteven GonzalezNov 5, 2025
If the burner on your Hydro Tek Pressure Washer doesn't ignite, there are several things to check. First, ensure the burner switch is in the "ON" position and the thermostat is set to a higher temperature. Make sure there's enough fuel, above the pick-up tube level in the tank. Install a spray tip, as the burner needs 1000 PSI to operate. If you have a dual lance wand, close the valve to increase pressure and verify the nozzle size. Inspect the unit for damaged O-rings, hoses, or the trigger gun, and replace them if necessary. Reset the breaker or replace the fuse, looking for any shorts or overloads. Also, check the belt tension and adjust the engine RPM. Use a multimeter to check the heat switch/thermostat for continuity (thermostat must be adjusted to the highest setting before testing-...
General